36
W415-0812 / D / 08.16.12
When using a non-combustible
fi
n-
ishing material, the stand-offs may
be removed, by removing the set
screw in the centre and sliding the
stand-offs out of the mounting clips.
* The top extension may be re-
moved if non-combustible framing
is faced with a non-combustible
material placed
fl
ush with the front
face of the appliance and extend-
ing from the top of the appliance.
Example:
Cement board (not sup-
plied). Combustible counter / bar
tops must maintain a minimum of
38" from the base of the appliance
to the underside of the top.
NOTE: Wolf Steel trim and/or surround kits will not to-
tally cover the top extension of the appliance. In order
to obtain a smooth transition from the trim / surround
to the wall, it is recommended that the top extension
be removed and the appliance be installed following
the above procedure.
9.3 HEAT SHIELD STAND-OFF REMOVAL (SEE-THRU INSTALLATION ONLY)
END HEAT
SHIELD SHOWN
9.4 LOUVRE
INSTALLATION
A
B
C
SLOT
A
B
C
CLIPS
CENTRE SLOT
TAB
SLOT
HINGE CLIP
57.2
UPPER LOUVRES
Insert the louvre tabs
into the slots located
at the top left and right
corners of the unit.
LOWER LOUVRES
Insert the hinge clips
into the slots located at
the bottom left and right
corners of the unit. To
remove the louvres, pull
the back tabs of the clips
forward, while pushing
the louvre assembly
back. Lift the clip.
HOOD
Attach the hood by
pressing the top
fl
ange
into the clips along the
top of the louvre open-
ing. Secure using a
screw through the centre
slot.
Содержание BCDV40-N
Страница 51: ...51 W415 0812 D 08 16 12 17 0 SERVICE HISTORY 43 1...
Страница 52: ...52 W415 0812 D 08 16 12...