4
Be sure to tighten the cable clamp screws securing both the
Ethernet cable and the braided shield to the panel enclosure.
8
. Plug the Ethernet cable into the Ethernet board receptacle.
9
. Re-connect power to the system, including the battery wires.
Verify that the OK lamp (LED) on the Interface board blinks
on and off once per second. Also verify the heartbeat lamp on
the motherboard (location T1) blinks in unison with the OK
lamp on the Interface board.
Note:
The status LEDs on the top of the Ethernet board re-
ceptacle will blink when network activity is detected (see im-
age in Fig. 15 for the location of these status LEDs).
Note:
On the CICP2800PMBD Base Processor PC board,
be sure the MEMORY BACKUP CELL jumper is in the IN
position to provide memory data retention. See Fig. 16 below
and WI2044 for complete installation instructions for the
CICP2800PMBD.
Status LED's
Fig. 15: Location of status LED's. These
LED's will blink when network activity is de-
tected.
CLR
OU
T
IN
Fig. 16: "IN" Position
