CTLTAPE -
4-channel DMX wall-mounted controller
Page 4
English
This subtle and compact wall-mounted controller is a really intuitive device which will allow you to control
very precisely any colours of your installation.
Its two program memories offer a quick access to your favourite ambient lighting, while an extra button
allows you to use it as any standard power switch.
Initially designed for the POWTAPE, POW50R and POW100R, the CTLTAPE can also adapt to any product
with a compatible DMX chart.
2 - DESCRIPTION
2-1 : Overview
1
2
8
9
4
5
6
7
3
1 - FADE/COLOR Button
Activates Fade mode (sequences) or preset colours
(Color).
2 - SPEED/DIMMER Button
Allows you to adjust the sequencing speed (Speed)
in Fade mode or the dimming intensity (Dimmer) and
strobe speed.
3 - M1 Button
Allows you to save a scene. If a scene has already
been saved via this button, press it to replay this
scene.
4 - Stand-by LED
The LED is lit when the blackout mode is active.
It flashes when storing a scene.
5 - M2 Button
Similar to M1 button.
6 - Black-out Button
Activates the black-out mode, shutting off all LEDs.
7 - 5-pin connector
3 pins dedicated to DMX output (GND/DAT-/DAT+)
2 pins for 12V power supply unit (+12V/0V).
Please refer to chapter 3 for more details.
8 - Fastening holes
4 holes allow you to install your CTLTAPE.
Remove the lid (9), position your CTLTAPE, use two
screws to secure its position, then replace the lid.
9 - Lid
Covers fastening holes. Written instructions are
located on the lid.
Saving a scene:
- Adjust the scene settings (e.g. by choosing
colours and light intensity).
- Press and hold for 3 seconds one of the two M
buttons (1 or 2).
- The Black-out LED will flash to indicate the scene
has been saved.
- Short-press this button to replay this scene.
