Contec IPC-DT/H40X(PC)T, Руководство пользователя, Страница: 22 / 33

6. Connection to the Host Computer and Power Supply
User’s Manual
19
6. Connection to the Host Computer and Power
Supply
If using IPC or SBC products other than those listed here, refer to
their respective manuals for details of the settings.
Setting up the Host Computer
The IPC-DT/L40S(PC)T and IPC-DT/H40X(PC)T can be used with
host computers such as the CONTEC IPC Series and SBCs (single-
board computers). The host computer to be connected must be set
up correctly for using the display. Set the IPC-DT/L40S(PC)T to
SVGA (800 x 600) or the IPC-DT/H40X(PC)T to XGA (1024 x
768).
Set the LCD type as follows depending on the host computer to be
used.
PC-686BX(PC)-LV
To use this SBC board with the display, set the on-board switch
(U2) as shown below.
12.1-inch IPC-DT/L40S(PC)T 15-inch IPC-DT/H40X(PC)T
Set only 1 to ON
(TFT color LCD in 800 x 600) (TFT color LCD in 1024 x 768)
U2 U2
Set all bits to OFF.
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
Figure 6.1. U2 Switch Settings
Note!
Use this board along with the ISA bus type of LCD signal
conversion board [ADPLNK(PC)].