Contec CPS-MG341G-ADSC1-930, Справочное руководство

Страница: 31 / 93

—
Product Nomenclature and Function
—
CPS-MG341G-ADSC1-930 Reference Manual (Hardware)
— 31 —
12. DIP switch
SW1, SW2
DIP switch for system setup and RS-422A/485 setup of COM A.
The factory default of all switches are set to “OFF”.
DIP Switch
SW Bit No. ON/OFF Description
SW2 1 ON Enable the TX Terminator
OFF Disable the TX Terminator
2 ON Enable the RX Terminator
OFF Disable the RX Terminator
3 ON Internal connection state of TX+ and RX+: Short(Half Duplex)
OFF Internal connection state of TX+ and RX+: Open(Full Duplex)
4 ON Internal connection state of TX- and RX-: Short(Half Duplex)
OFF Internal connection state of TX- and RX-: Open(Full Duplex)
SW1 1 ON RTS Communication Mode: Half Duplex
OFF RTS Communication Mode: Full Duplex
2 -
2: OFF, 3: OFF This indicates it is set in the default setting.
2: ON, 3: OFF IP address setting starts up with default setting upon
turning on, while user/password and group settings
starts up with a user’s settings.
The current IP address, user/password and group
settings can be checked on the Web monitor.
2: ON, 3: ON Each setting will be initialized upon turning on.
LED PWR and ST1 will flash upon the completion.
Confirm the flashing and turn off the switch 2, 3, then
reboot.
3 -
4 OFF System Reservation: Always OFF
5 OFF System Reservation: Always OFF
6 OFF System Reservation: Always OFF
COM B USB RS-232C
1
ON
2 3 4 1 2 3 4 5 6
SW2 SW1
ON