Position the disc on the flange.
Place the flange nut on the spindle and tighten
using the spanner.
Release the spindle lock and check that the
spindle is unlocked by rotating it.
Make sure the disc is installed in the correct way
(direction of rotation)
Never press the spindle lock
before the motor and disc
have come to a complete
standstill!
Never use the spindle lock to
stop the motor. It will break.
Inspect discs regularly. Worn discs have a
negative effect on efficiency of the machine and
may cause severe injury to user or damage to
surrounding. Replace the grinding disc on time.
Mounting and removing the side handle
The side handle can be used for both left-hand and
right hand control.
§ Fasten the side handle for left-hand operation on
the right-hand side of the machine.
§ Fasten the side handle for right-hand operation on
the left-hand side of the machine.
_
Tighten the side handle (5) in one of the
mounting holes.
OPERATION
Special attention when starting the machine
§ Clamp the workpiece and make sure that the
workpiece cannot slide from under the
machine during the cutting activities.
§ When working with the machine, always hold it
firmly with both hands and provide for a
secure stance.
Always direct the cable to the rear away from the
machine.
§ Insert the mains plug only when the machine is
switched off.
§ Apply the machine to the workpiece only when
switched on
Be aware the screws are
tightened well enough. Check
regularly if the screws
are still fixed.
Speed control
The speed of the disc can be controlled with the
rotary knob on top of the handle. The higher the
position, the higher the speed.
Switching on and off
_
To run the machine, slide the on/offswitch
(1) in the direction of the grinding wheel.
_
To switch off the machine, you slide the
on/off-switch (1) back.
Never use the machine for
grinding magnesium
workpieces.
USE
§ Hold the machine firmly and move it against the
workpiece. Move the grinding disc evenly
across the workpiece.
§ Move the machine during roughing under an angle
of 30º - 40º across the workpiece
Never use grinding discs for
roughing!
§ The machine must always work opposite to the
direction of rotation. Therefore, never
move the machine in the other direction! Otherwise,
the danger exists of it being pushed
uncontrolled out of the cut.
§ Inspect the grinding disc regularly. Worn discs
have a negative effect on efficiency of the
machine. Replace the grinding disc on time.
§ Do not put the machine down when the motor is
still running. Do not place the machine on
a dusty surface. Dust particles may enter the
mechanism.
§ Always switch off the machine first before
removing the plug from the wall socket.
Never use the spindle lock to
stop the motor.
CLEANING AND MAINTENANCE
Attention! Before
performing any work on
the equipment, pull the
power plug.
Service
§ Only qualified specialist personnel and original
replacement parts should be used for repairs. This
will ensure that your device remains safe.
Cleaning
§ Regularly clean the machine housing with a soft
cloth, preferably after each use. Keep the
ventilation slots free from dust and dirt. If the dirt
does not come off use a soft cloth
moistened with soapy water. Never use solvents
such as petrol, alcohol, ammonia water,
etc. These solvents may damage the plastic parts.
Lubrication
The machine requires no additional lubrication.
Checking and replacing the carbon brushes
The carbon brushes must be checked on a regular
basis.
_
Remove the carbon brush holders and clean the
carbon brushes.
Содержание 5411074183592
Страница 2: ...6 1 2 8 4 7 8 5 ...
Страница 52: ......
