8
987-013C_v01
●
Wash all accessories thoroughly before the initial use.
●
Assemble the appropriate accessories and install them
on the motor.
2
Plug in the appliance.
3
Switch on the appliance using the
“I”
switch
(1a)
(the appliance starts to operate after about 2 seconds).
Operation with the sausage filler nozzle
Insert the following parts into the mincer body
(2)
:
1
Insert the scroll
(3)
with the coupling facing inside.
2
Fit the insert
(9)
onto the pin of the scroll
(3)
.
3
Fit the sausage stuffing tube
(10)
.
4
Tightly fit all the elements with the threaded ring
(6)
.
5
Fit the assembled mincer unit onto the drive unit
(1)
and
turn it until you hear a click of the lock.
6
Place the tray
(7)
on the mincer body
(2)
.
Soak the casing for about 10 minutes before fitting.
●
Fit the wet casing on the sausage filler nozzle.
Make sure the not to block the ventilation
openings on the nozzle.
The meat cannot be “too thin”. A large liquid
content may cause its leakage to the inside of
the mincer.
After operation
●
Switch off and unplug the appliance.
1
Remove the pusher
(8)
and take out the tray
(7)
from the
mincer body.
2
Press the lock button, turn the mincing unit to the right
and remove it.
3
Dismantle the elements of the mincing unit, the body with
the sausage filler nozzle.
Store the clean and dry screens in the compartment. In order
to do so:
4
Open the compartment on the back of the housing.
●
Press the compartment lock on both sides and pull
(as shown earlier).
5
Store up to two screens and close the compartment and
the back lid.
6
Put away the cord, pushing it gently through the opening.
●
Place the plug in the compartment.
Cleaning and maintenance
●
Wipe the motor with a damp cloth with dishwashing
liquid.
●
Wash plastic elements in warm soapy water or in the
dishwasher according to the denotations.
●
Wash metal elements in hot soapy water.
●
Dry all elements thoroughly.
F
G
●
Grease the screens and cutter with cooking oil to protect
from rusting.
●
Assemble dry elements of the mincer body or the
shredder.
Ecology – Environment protection
Each user can protect the natural environment.
It is neither difficult nor expensive.
In order to do it: put the cardboard packing into
recycling paper container; put the polyethylene
(PE) bags into container for plastic.
When worn out, dispose the appliance to particular disposal
centre, because of the dangerous elements of this appliance,
which can be hazardous for natural environment.
Do not dispose into the domestic waste disposal!!!
The manufacturer does not accept any liability for any damages
resulting from unintended use or inappropriate handling.
The manufacturer reserves his rights for modifying the product any
time in order to adjust it to law regulations, norms, directives, or due
to construction, trade aesthetic or other reasons, without notifying it
in advance.
