2
Issue 01
The CRXLC controller can be powered either by a 5V power
adapter with a micro USB connector, supplied power
adapter via USB port or 4 AAA batteries. There are 2
available USB ports for power. One port is located on the
bottom and one at the back of the controller.
7. Power options
5. Heat symbol on the display
6. Status light on the heater
Every time there is a demand for heat, the display will show
the heat icon.
- reduced heat output when the room temperature is
close to the set temperature.
- full heat output
Light colour Heater status
STAND-BY No heat output
Reduced heat output
Full power heat output
FAULT - Overheating
FAULT - Connection with CRXLC lost
FAULT - Connection with CRXLC lost
Heater is ready for pairing with CRXLC
Remove the CRXLC’s battery cover and insert 4 new high
quality alkaline AAA batteries.
Warning
: Consort is not responsible for damage due to
corrosion. Battery leakage will cause permanent damage.
Do not use batteries when unit is powered on with mains.
To help avoid battery leak:
Replace the batteries annually, even if there is not a
low battery warning. Remove failing or flat batteries
immediately.
Always fit a pair of new high quality alkaline batteries
from the same pack. Never mix new and old batteries,
or batteries of different brands or types.
Never attempt to revive alkaline batteries by heating,
crushing or recharging.
8. Batteries
9. Power adapter for fixed installation
The CRXLC controller is supplied with a power adapter that
will fit a 35mm or a 25mm metal or dry lining back box. The
power adapter should only be connected to a wiring
protected by a 3A fuse. Connect line and neutral conductors
to the terminal block. Please note that the adaptor supplied
with the controller must be installed exactly as the figures
show, otherwise the USB connector will not fit correctly. The
centre of the back box must be kept clear to allow room for
the USB connector.
When fitting the wall bracket, ensure that the adaptor is
installed properly and feed the cable through the centre of
the bracket. Screw the bracket to a back box taking care
not to damage the power adaptor or leads by long screws.
Connect the USB cable into the power port at back of the
controller as shown on the photo. Check that the CRXLC is
working. Attach top of the CRXLC to the wall bracket and
slowly tilt it to place observing that the USB connector is
moving in to the opening freely. Once the controller is in
place secure the two screws on the bottom of the controller.
Please note that the controller screen will take up to
one minute to display after powering up for the FIRST
time.
locking screws
USB power ports
temperature sensor
wall fixing
wall fixing
