Consew 104-1T, Каталог запасных частей и инструкция по эксплуатации

Страница: 8 / 38

TO THREAD THE MACHINE
Place the cone of thread in a convenient position on the floor.
Three thread eyelets are furnished with machine. These eyel ets should
be fastened to the underside of the t able as shown at 1, 2 and 3, Fig. 4.
Eyelet 1 should be located directly above the cone of thread.
Pass the thread up from the cone and t hrough eyelets 1, 2 and 3, then
through hole 4, over between tension di scs 5, through thr ead controller 6.
Turn handle K, Fig. 5 to the front or slightly to the left, raise presser foot and
insert threading wire S in the forward hole 7 of needle plate. With the lef t
hand, catch thread on hook of threading wire S and draw wire and thread up
through hole of needle pl ate. With the left hand, hold end of thread with a
slight tension.
With the right hand, turn handle K strai ght to the left and, having started
the machine, quickly bear down and up on handle K so that the needle will
pick up the thread for one stitch.
Keep handle K in same position and, with the threading wire, draw thread
directly toward you laying end of th read loosely on needle pl ate after it
comes up through needle hole. The machine is then ready for operation.
7
Downloaded
from
www.aberdeensewing.com