49
Example: Activate alarm when the indoor humidity drops below 30%
• Briefly push the “ALM” button. “HI AL” appears in the top right of the display.
• Briefly push the button “ALM” again; “LO AL” appears in the upper right of the display.
The alarm mode “HI AL” must be used when an alarm is to be output if the measured
value exceeds the value set by you.
The alarm mode “LO AL” must be used when an alarm is to be output if the measured
value undercuts the value set by you (this is the case in the example used!).
• Briefly push the button “SET” repeatedly until the value for the indoor humidity flashes.
Set a value of 30% with the button “+” or “MIN/MAX” (for quick adjustment, keep the
respective button pushed).
• While the value flashes, the alarm can be switched on (icon “
” appears in the display of
the weather station in the outdoor sensor area on the right of the time) or off (icon disappears)
by briefly pushing the button “ALM”.
• There are three ways of leaving the setting mode as described above:
- Push the button “SET” briefly repeatedly until the regular display appears again
- Briefly push the button “SNOOZE/LIGHT”
- Wait for 10 seconds without pushing any button
