20
Safety Notices
Please read all operating instructions before using the product for the first time;
they contain important information about correct operation.
The guarantee/warranty will be void if damage is incurred as a result of non-com-
pliance with the operating instructions. We will not assume any responsibility
for consequential damage!
We do not assume any liability for material and personal damage caused by
improper use or non-compliance with the safety instructions! In such cases the
warranty/guarantee is void.
To ensure safe operation, the user must comply with the safety instructions and warnings contained in
these operating instructions.
For safety and licensing reasons, unauthorized conversion and/or modifications to the set are not per-
mitted.
The device is intended only as an aid for reversing; it does not release the driver from his or her duty of
due diligence. As a result of the mode of operation of the device, some obstacles may not be detected
correctly or at all.
The device is only fully functional during slow reversing. The warning may not be sent in time if the vehi-
cle is moving at greater speed.
The device’s performance may be negatively affected by large amounts of dirt on the sensors or by the
effects of exhaust gas.
The sensors must not obstruct the vehicle’s rear lights, the number plate or any other part of the vehicle’s
equipment and they must be flush with the edge of the vehicle.
When installing and operating the set, observe the valid registration and traffic regulations.
Prior to all installation work, always disconnect the negative pole of the battery. This prevents the danger
of short circuits. Do not connect the negative pole of the battery until you have completely connected the
system and checked the connections. Observe the vehicle manufacturer’s instructions to ensure your do
not lose vehicle-specific data memory.
You should only use a voltmeter or a diode test lamp for checking the voltage on the on-board cables as
normal test lamps draw too high a current and can thus damage the electronic system of the car.
When installing cabling, you must ensure that it is not crushed and does not rub against sharp edges;
you should use grommets at the inlet points.
Содержание 85 69 98
Страница 59: ...59 ...
