26
15. Brief instructions
a) Registering the door/window detector with the
alarm base station
• Install the door/window detector, but do not insert batteries yet
• Set the alarm base station to the sensor search mode
• Insert batteries into the door/window detector
• The alarm base station should now recognise the door/window detector
• Enter a name for the door/window detector
• Set properties for the door/window detector (closure group and internal/external
sensors)
• Return to the top level of the alarm base station (press the ‘
w
C
’ three times)
• If the internal magnet sensor is to be used (in connection with the supplied
magnets), open and close the window 1 time, in order to activate the magnet
sensor
b) Further connection of external NC/NO contacts
• Set the door/window detector on the alarm base station to the maintenance
mode
• Open the door/window detector’s casing
• Lay or change wiring
• If NO contacts are to be attached to the ‘KL1’ terminal, 3 additional type
LR44 button cells must be inserted
• If NC contacts are to be connected to the ‘KL2’ terminal, the jumper (factory
installed) on the ‘KL2’ terminal must first be removed.
• Close the casing
• Exit the maintenance mode of the alarm base station
• If the internal magnet sensor is to be used (in connection with the supplied
magnets), open and close the window 1 time, in order to activate the magnet
sensor again
The door/window detector may also be operated exclusively with
external NC/NO contacts, the internal magnet contact is always
automatically deactivated after batteries have been replaced.
