Connex Connex350, Руководство по эксплуатации и техническому обслуживанию

Страница: 52 / 68

Operating & Maintaining the Connex500/350 3-D Printer
7–52
DOC-13000 Rev. E
4. In the next wizard screen, observe the numbers and wait until the level
is relatively stable—two units above or below the average level shown.
Figure 7-81: Load cell calibration screen
5. Select the Weight is stable check box, and click
Next
.
If you need to calibrate more than one load cell, the next calibration
screen appears. Repeat steps 4 and 5 until all of the load cells are
calibrated.
6. Click
Done
in the final wizard screen.
Figure 7-82: Final wizard screen
Replacing the
Odor Filter
The Connex500/350 printer has an activated ‐ carbon filter for removing
odors from printing materials. The filter should be replaced regularly
(about once a year, as necessary) to keep your working environment
pleasant. This is normally done during the yearly preventive ‐ maintenance
service visit.
Replacing the
UV Lamps
The UV lamps used for curing models have a long, but limited, working
life. The Objet service engineer tests their effectiveness during regular
maintenance checks, and replaces them, if necessary. You can test and