Connex Connex350, Руководство по эксплуатации и техническому обслуживанию

Страница: 48 / 68

Operating & Maintaining the Connex500/350 3-D Printer
7–48
DOC-13000 Rev. E
•
If the replacement head was not factory ‐ calibrated, the following
warning screen appears.
Figure 7-74: Invalid-data warning screen
If this happens:
a. Remove the head and replace it with another one (starting with step
9 on page 7 ‐ 42).
b. In the wizard screen, select the check box to confirm that you have
installed another print head, and click
Next
.
c. Contact your authorized Objet Customer Support center about the
unformatted head.
•
If the vacuum test is not successful, the replacement head was not
sealed properly during installation, and the following warning screen
appears.
Figure 7-75: Vacuum Leakage warning screen
If this happens:
a. Click
Next
.
b. Follow the instructions on the wizard screens to re ‐ install the head.