CMx2-DisplayPort
CMx2-HDMI
Media Converter
Instruction Manual CMx2 Media Converter
page: 7
Receiver
Switch position
Signal assignment
Standard setting „Default"
Automatic setting
Manual operation „Manual"
Special settings for EQ / VOD / Pre-
emphasis
Possible Operation Errors CMx2 DisplayPort
Error
Possible reasons
Debugging
Notes
LED is off
The devices do not get any
power
Überprüfen sie die einwandfreie Funktion der
Netzspannung
Green, steady flashing
on the receiver
1.) The module detects an
open fiber connection
2.) The fiber optic cable is too
long, or has increased attenua-
tion values
1.) Check if the fiber optic cable is plugged
2.) Check the proper function of the fiber optic
cable
Green, steady flashing
on the transmitter
HPD (Hot-Plug-Detect) monitor
signal is declared low
1.) The connection from the source to the
monitor is lost. There can be no communication.
Check the DisplayPort cables and the fiber optic
connection
2.) Remove the mains cord, connect all
communication cables and reboot the system
LED goes out (2-3 sec.)
Then flashing on the
receiver
EDID transmission error
1.) The connection from the source to the
monitor is interrupted. There can be no
communication.
Check the DisplayPort cables and the fiber optic
connection
2.) Remove the power cord connect all
communication cables
LED goes out (2-3 sec.)
Then flashing on the
transmitter
EDID transmission error
1.) The connection from the source to the
monitor is interrupted. There can be no
communication.
Check the DisplayPort cables and the fiber optic
connection
2.) Remove the power cord connect all
communication cables
Switch position
Signal assignment
Standard setting „Default"
Minimum DP- Output level (recommended)
Manual Operation „Manual"
Maximum DP-Output level
Transmitter
The CMx2 DisplayPort media converter provides two modes of
operation, which can be set via the mode switch.
Operating Modes CMx2 DisplayPort
