Connected IO Inc., CONFIDENTIAL
24
EMU Router User Manual: ER2500T-XX-CAT1
Revision: 3.0
•
Verizon Open Development Certification
9.3.
FCC General Warning
This equipment has been tested and found to comply with the limits for a Class B Digital Device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
and correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
Any changes or modification no expressly approved by the grantee of the device could void the user’s
authority to operate the equipment.
RF exposure warning
This equipment must be installed and operated in accordance with provided instructions and the
antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm
from all persons and must not be co-located or operating in conjunction with any other antenna or
transmitter. End-users and installers must be provided with antenna installation instructions and
transmitter operating conditions for satisfying RF exposure compliance.
Detachable Antenna:
This M2M Router device, ER2500T-NA-CAT1 and ER2500T-VZ-CAT1, integrates an LTE (4G) and WiFi
radio function. Is uses an external antenna (dipole antenna) and a standard antenna connector (SMA
type) which is not covered under FCC 15.203 requirements. Therefore, this equipment needs to be
installed by a professional technician since the M2M application usually resides inside other equipment
where the end-user cannot change the external antennas easily. There is no doubt that the antennas can
be replaced by the end-user once installed in the final configuration.
