Safety Tips
⚫
Whilst all care has been taken to remove sharp edges, care must be taken when cleaning or handling the sink to prevent risk of
injury from exposed metal edges.
⚫
Do not overload the sink top or shelf this may cause it to bend.
Pack Contains
⚫
1x Stainless steel Sink top shelf (A)
⚫
1x Galvanised steel undershelf (B)
⚫
4x Galvanised Steel Legs ( C )
⚫
16 x Screws (D)
⚫
1x Allen key (E)
⚫
1x Waste Fitting (F)
⚫
1x
Standpipe (G)
Assembly
Note: Be sure to check all packaging materials for any small parts that may have come loose during transportation
1.
Remove all packaging including all protective packing material from top shelf, legs and undershelf, taking care to avoid
scratching the surfaces.
2.
Place the sink face down on the floor [A]
3.
Position the corner sockets of the undershelf over the four legs and lower the shelf approximately 25 cm (As per your required
height) down the legs.
Note: The legs are marked at 25 cm (or your required height) to help position the undershelf in a level position.
4.
Hold the shelf in position and insert the grub screws to loosely secure the shelf to each of the legs.
Note: Leaving the grub screws loose allows for adjustments to sink shelf and legs.
5.
Insert the legs with shelf into the sockets situated at each corner of the sink (top shelf)
6.
Adjust the shelf and legs so that they are level (use a spirit level if required)
7.
Tighten all the grub screws.
8.
Stand the sink upright and remove the remaining protective film.
9.
If necessary, adjust the feet to level the sink.
10.
Place the fully-assembled waste fitting into the drainage hole, then attach the rest of the parts and fit together.
(please refer to waste fitting instruction below)
11.
When you put the standpipes into the waste fitting, please take out the basket part of waste fitting first.
Содержание HEF721
Страница 2: ......
