9 421027 594821
Ecomix Cast Spout Basin Mixer
VECM020
Voda Plumbingware Limited | Freephone: 0508 367 366 | 5 Hewlett Street, Port Whangarei 0110 | vodaplumbingware.co.nz
Congratulations on your purchase of this high quality product from Voda Plumbingware.
Please read the following before installation and retain (along with your receipt) for future reference.
TECHNICAL SPECIFICATIONS
Suitable for All Pressures
Minimum Pressure = 17kPa
Maximum operating Pressure = 500kPa
Maximum operating Temperature = 65 deg. Celsius
For domestic use only.
CONFIGURATION
Mains Pressure systems Remove the valve insert from the valve nipple and change aerator to the WELS rated one
supplied.
Unequal Low systems Ensure the valve nipple is attached to the cold in-feed hose (flow arrow aligned to the
water flow).
Equal Low systems
Remove the all valve insert from the valve nipples.
INSTALLATION
For pressures exceeding 500kPa, install a pressure limiting valve. Failure to do so may void the warranty.
• Before commencing installation turn off the water supply.
• Position tap in 35mm hole, making sure the seal between tap and supporting surface is in place.
• Anchor to bench with fittings pack.
• Where applicable, it is important to ensure the base ring is hand-tight on the mixer, prior to installation.
• Thoroughly flush all pipes to eliminate any remaining dirt and residue and install inline filters.
• Connect supply hoses to plumbing connections.
Minimum bend for flexible hose is 35mm radius.
Do not stretch, crush or twist hoses. Do not swage hose ends.
• Turn on mains supply.
• Check for leaks.
Plumbers Note: Do not pressure test this mixer under static pressure.
