Connect PowerNet 3270, Справочное руководство

Страница: 25 / 73

Connect, Inc. Host Connection Setup
February 1998 2-13
Devices
[Toggle Field] This setting allows configuration of the maximum
number of LUs (logical units) that can be established on the defined
controller. Values for this field can be 8, 16, 32, 64, 128, or 254. This
value sets the number of LUs that can be managed by the PowerNet
server. This setting should match the controller settings as defined on
the host system. If the value for this field as set on the server exceeds
the allowable number of LUs as defined on the host, terminals
mapped to unallowed LUs are not be able to attach to the host system.
Caution
Keep in mind that this value can be set to exceed the number of
active terminal sessions that the server may be configured to
support. Although this may be true, the server as configured only
permits the allowable number of active terminals in session with
the host computer at any one time.
TN3270 Setup
Select
Setup
from the
TN3270 Network Menu
to display the
TN3270 Setup Form
shown in Figures 2-9. Connection address information, supplied by the host
system administrator, is entered on this form. Selection of the station addresses is
accomplished by toggling through the available connections as set under TCP/IP
Addresses from the TCP/IP Network Menu. See the TCP/IP manual for TPC/IP
address setup information.
TN3270 Setup
Hosts
0 [trn2501p ] 4 [trn2001a ]
1 [trn2001a ] 5 [trn2501a ]
2 [trn1000l ] 6 [trn2501p ]
3 [trn1000r ] 7 [ttysrv ]
<ESC>=QUIT <SPACE>=CHANGE <ARROWS>=MOVE
Figure 2-8 TN3270 Setup Form
SNA Startup
After configuring the necessary host connection links and controllers, the host
network link must be started. Return to the
Operations Menu
and select
SNA
Startup
, then press <
Enter
>. The process begins and an on-screen list of events
are displayed as they occur, as illustrated below.
SDLC Start UP
Status check ...