SCREW, M2.0, 4.0 mm, PPHMS; QTY. 4
FAN/HEAT SINK
PLUG FAN WIRES INTO THIS CONNECTOR
(
REFER TO MAUAL
)
SHEET 7 OF 12 CTIX-00482(0.02) 07/12/2018
DRESS THE FAN WIRES AS SHOWN IN FIGURE 3.
1.
REMOVE THE PROTECTIVE FILM FROM THE THERMAL PAD ON THE UNDER
2.
SIDE OF THE FAN/HEAT SINK. THESE PAD HAS A 'STICKY' FEEL. KEEP IT
CLEAN FROM ANY DEBRIS.
CAREFULLY PLACE ON TOP OF THE TX MODULE - ALIGNING THE
3.
MOUNTING HOLES. DO NOT APPLY PRESSURE AS NOT TO STICK THE HEAT
SINK TO THE MODULE SHOULD A RE-ALIGNMENT BE REQUIRED.
LOOSELY FASTEN THE HEAT SINK USING THE SCREWS IN 4 PLACES.
4.
TIGHTEN ALL FASTENERS IN AN "X" PATTERN.
5.
TOOL: PHILLIPS SCREWDRIVER
FAN/HEATSINK INSTALLATION
STEP 4:
FIGURE 3
IF THE MODULE DOES NOT ALREADY HAVE THE FAN/HEAT SINK ASSEMBLED FOLLOW THESE STEPS;
RECOMMEND LIGHT DUTY THREADLOCKER ON THREADS ON SCREWS.
RECOMMEND TORQUE TIGHTEN THE SCREWS TO 1.5 in-lb.
