ConMed Hall MicroPower 6020-026, Инструкция по эксплуатации

Страница: 7 / 40

3
(c) Attach the guard and bur to the
handpiece.
(d) Operate the handpiece for
approximately 30 seconds, then stop
the handpiece. Once the bur has
stopped moving, carefully feel the end
of the guard where the guard encases
the shaft of the bur for overheating. If
overheating is noticed, return guard for
service.
12. After each use, thoroughly clean the con-
troller, handpieces, attachments and acces-
sories (See
“3.1 Cleaning and Sterilizing”
on page 21 ).
13. Do not use in the presence of flammable
anesthetics, gases, disinfecting agents,
cleaning solutions, or any material suscepti-
ble to ignition due to electrical sparking.
1.3 Symbol Definitions
Attention, consult accompany-
ing documents
Type B equipment
Single Use Only
Eye Protection Required
No user service recommended.
Refer servicing to qualified
ConMed
Linvatec service per-
sonnel.
Indicates product component
should not be sterilized.
Indicates product component
should not be immersed in any
type of fluid.
Indicates handpiece should not
be immersed in any fluid.
Indicates product should not be
oiled or lubricated.
Not to be used for plunge cut-
ting
Caution: Federal Law restricts
this device to sale by or on the
order of a physician.
WEEE (Waste Electronics
and Electrical Equipment)
Symbol. Regarding Euro-
pean Union end-of-life of
product.
Rx ONLY