Conmec CT436E, Руководство оператора

Страница: 13 / 19

13
3.8 To Stop
Reduce RPM to “0” by moving the speed control. Release the safety stop switch. Turn the key
switch to “OFF”.
3.9 Speed Control
The motor speed can be set on Auto and Manual mode.
Speed Control on Auto: In Auto speed mode, adjust the motor speed suitable for real-time working
conditions, clockwise to increase, counterclockwise to decrease MIN(0 min/n)~MAX(120 min/n).
Speed Control on Manual: In Manual speed mode, turn the handle for adjust speed.
3.10 Pitch Adjustment
To adjust blade pitch (angle) by fast pitch control. Pull the control knob all the way reverse
(towards to the operator) to increases the pitch of the blades. Push the control knob all the way
forward (away from the operator) to flattens or decreases the pitch of the blades.
3.11 Floating Operation
Attach float blades to the trowel arms, and when the concrete has set sufficiently to support the
weight of the trowel, place the unit on the concrete. Start the unit and engage the blades as
previously instructed. Using the tilt adjustment knob to adjust the blades to the float
position-blades should be as flat to the concrete as possible with enough tension kept on the tilt
adjustment cable to prevent the unit from dancing or chattering.
OPERATION
This operation will bring the water and fines to the surface, allowing for a smoother finish when
finishing the concrete.
3.12 Finishing Operation
After floating, allow the concrete to set until it will support the weight of the trowel. Set the
pitch to approximately 1/4” to 3/8” on the blades. If the blades start to dig into the concrete,
decrease the amount of pitch.