BEC62(08) technical manual
14
Installing the user interface unit (UIU)
1.
Place the wall mount bracket against the wall, ensuring that the unit is level and that the
communication cable can pass through the cable entry hole (
Figure 3-1
-A).
2.
Mark and drill 6mm holes for the two mounting holes and insert the wall plugs (
Figure 3-1
-B).
3.
Pull the communication cable through the cable entry hole. Ensure that no more than 100mm of
cable is protruding.
4.
Insert and tighten all screws ensuring the base is securely fastened in position and is not
twisted or distorted.
5.
Cut and strip the ends of the communication cable. To ensure a good connection, we
recommend that at least 15mm of cable is stripped.
6.
Connect the communication wires for the UIU by pushing back on the orange clips and inserting
the wires (
Figure 3-2
-A).
7.
Curl up the surplus communication cable, ensuring that it does not get damaged when securing
the unit to the bracket.
8.
Slide and clip the unit onto the base (
Figure 3-3
-A).
9.
Insert and tighten all screws, ensuring that the unit is securely fastened in position. (
Figure 3-3
-
B).
Figure 3-1: UIU base view
Mounting bracket
holes
Communication
cable entry point
