Copyright
©
2015
congatec
AG
TCEDm11
25/96
5.1.10
LCD
The conga-TCA offers an LVDS interface on the AB connector. The interface supports:
•
single channel LVDS with color depths of 18 bpp (D2000/N2000 series) or 24 bpp (D2000 series only)
•
integrated flat panel interface with clock frequency up to 112 MHz
•
VESA and OpenLDI LVDS color mappings
•
automatic panel detection via Embedded Panel Interface based on VESA EDID
TM
1.3
•
resolution up to 1366x768 for 18 bpp and up to 1440x900 for 24 bpp
5.1.11
SPI
A SPI interface that supports booting from an external SPI flash is available on the conga-TCA via the Intel
®
CG82NM10 (NM10) PCH . The
Intel
®
CG82NM10 (NM10) PCH implements a SPI interface as an alternative interface for the BIOS flash device. A SPI flash device can be used
as a replacement for the Firmware Hub
5.1.12
General Purpose Serial Interface
Two TTL compatible two wire ports are available on Type 6 COM Express modules. These pins are designated SER0_TX, SER0_RX, SER1_TX
and SER1_RX. Data out of the module is on the _TX pins. Hardware handshaking and hardware flow control are not supported. The module
asynchronous serial ports are intended for general purpose use and for use with debugging software that make use of the “console redirect”
features available in many operating systems.
Note
The General Purpose Serial Interface is not supported on the conga-TCA module.
5.1.13
General Purpose Input/Output
The conga-TCA provides various general purpose inputs and outputs for custom system design. These GPIOs are provided via Intel
®
CG82NM10
(NM10) and routed to the A,B connector through the congatec Board Controller (STM32F100R8).
