CONGA 05708, Инструкция по эксплуатации

Страница: 29 / 34

CONGA ROCKSTAR 700 ULTIMATE ERGOFLEX | 29
ENGLESK
6. WET ACCESSORY FOR SCRUBBING
When the vacuum cleaner is not going to be used for a long time, please
remove the water tank and empty the remaining water. Do not expose it to
direct sunlight or to damp environments.
Mop installation/removal
Removing/installing the water tank
Fig. 25
In order to install/remove the cleaning cloth you must first disassemble
the water tank from the rest of the appliance. In order to remove the water
tank, use your foot to hold it against the ground and pull upward until it
unclicks from position.
Once the cloth has been installed and the water tank has been filled, to
reinstall the water tank, simply push it back together until it clicks into
position.
Note: Do not use cleaning agents. Use clean and room temperature water
only. Do not use the vacuum cleaner to vacuum water.
Installing the mop cloth
Place the mop cloth on the ground with the Velcro facing upwards. Align
the mop cloth with the Velcro strips on the water tank and attach it.
Fig. 26
Water emission
Fig. 27
When using this product for the first time, make sure the water tank lid is
not fully open.
When not in use, pay attention to the water emission push button and to
the tank lid, as water leak may occur when the water tank is full.
To activate water emission, the water emission push button must be
pressed, and to stop water emission, the push button must be released as
shown on the following figure.
Note: If the vacuum cleaner is not going to be used for a long period of time,
make sure to remove the water tank and to empty the remaining water. Do
not expose it to direct sunlight or to damp environments.
Removing the mop cloth
To remove the mop cloth, just hold it with your hand and pull form it to
detach it from the water tank.