CONGA 05708, Инструкция по эксплуатации

Страница: 25 / 34

CONGA ROCKSTAR 700 ULTIMATE ERGOFLEX | 25
ENGLESK
important that suction base rests on the floor to avoid the charging base
from holding all the vacuum cleaner’s weight. Make 3 holes on the wall and
fix the charging base with the supplied M4 x 32 nuts and screws.
The height should be 102.5 mm from the base of the wall charging base to
the ground.
Make sure that the charging base is securely fixed on the wall, place the
vacuum cleaner on the charging base as shown in figure 5 by putting the
vacuum cleaner’s charging terminals into contact with the charging base’s
ones (plastic tab).
Fig. 5
Once the wall charging base is installed, the charging port must be
connected to the power adapter, and then the device can be charged by
sliding it from top to bottom into the wall charging base.
Charge and display
When the battery percentage is 20 % or below, the device will automatically
enter low consumption mode. It is recommended to charge the device
when it reaches this percentage.
The battery must be charged while it is inside the device, and on the fast
charge base.
Connect one of the ends of the power adapter to the power supply and the
other to the fast charge base. During charging, the charge light indicator
will turn on red and will turn green once the charge is completed.
In order to charge only the battery, plug the power adapter and connect
the other end of the cord to the battery. During charging, the charge light
indicator will turn on red and will turn green once the charge is completed.
The display will show the battery charge.
Fig. 6
Charging modes
Charging mode 1
Fig. 7
Fig. 8
Charging mode 2
Fig. 9
Charging mode 3
Fig. 10