6.
7.
Place the second ladder leg with
the keyhole inserts removed over
the treads and tap down.
8.
Tap the ladder leg down onto the
ends of the treads.
Push the end of
one of the
standard treads
into the upper-
most keyhole
slot. Make sure
that the tread and
the ladder leg
are positioned as
shown in the pho-
tograph to the left.
It may be
necessary to tap
the tread into the
slot with a mallet.
Repeat for three
additional treads.
Slip the four extension
boots over the ends of
the ladders legs. They
will need to be all the
way on for most 52”
tall pools and backed
off one hole for 54”
pools. Depending
upon ground levels
outside the pool, and
sand
levels under the liner
inside the pool, a
final adjustment may
need to be made after
the ladder is put into
place.
If the round
plastic inserts,
on the sides
of the exten-
sion boots,
are still in
place, remove
them with a
phillips head
screwdriver as
shown.
1.
2.
4.
3.
Using four 1/4-20 x 2” long bolts
and four acorn nuts fasten the
extension boots to the ladder legs
Using a Phillips screwdriver, knock
out all four of the keyhole slot inserts
from two of the ladder legs.
Place handrail over the flat area located on top
of ladder leg. Insert one of the 1/4 - 20 x 1” bolts
through the ladder leg into the handrail. Place
one 1/4 - 20 hex nut into the recessed area on the
handrail and tighten using a Phillips screwdriver.
Install the second bolt and nut. Repeat to assem-
ble all four ladder leg/handrail assemblies.
5.
3
