Step 2.
Two sets of Lug
locations are provided.
Attach 4 upper treads
to the stringers in the
position determined by
the pool height.
Tread Lugs
Use upper
lugs for
50” to 54” pools.
Use lower
lugs for
42” to 48” pools.
Step 4.
Using a pair of pliers twist
off the wedges that are
attached from the end of
the platform and
SAVE
for
use in step 5.
Wedges
Protrusion
Detach
Wedges
Step 5.
Assemble the platform
to the handrails by laying
one of the handrails on a
clean hard surface. Push
the protrusion of the plat-
form into the openings
of the handrail making
sure that the legs of both
handrails are facing in the
same direction. Tap the
4 wedges (from step 4)
into the sides of the
handrails to secure the
platform to the rails.
Match
Platform
protrusions
to Handrail
openings
After platform is in
position, tap in the
supplied wedges at
the bottom of each
opening to ensure a
secure fit
Push
down
Step 6.
If needed, coat tubes
with liquid soap or
lubricant and slip
the adjustable tubes
through the mounting
blocks all the way
down over the
protruding nubs.
Mounting Block
Adjustable tube
Slide mounting
blocks over nubs
Step 3.
Secure the
upper treads
by driving
#10 x 1-1/4”
screws through
the recessed,
pre-drilled holes
in the ends of
each tread as
shown. Repeat
for all 4 upper
treads.
3
Step 1.
Snap stringers
into bottom tread.
If necessary lift
the two stringers
off the ground,
with the bottom
tread attached,
and drop them
firmly so that the
stringers “snap”
into the tread
pockets. The
bottom tread
should pivot freely.
Tread Lugs
Make sure the
single row of
tread lugs are
facing forward.
