Hardware Pack
26 - #10 x 1-1/4” screws
2 - Mounting Blocks
2 - Adjustable Tubes
Tools Needed for Assembly
* - Cordless Drill
* - 1/8” Drill Bit
* - Phillips Screwdriver
or screwdriver bits
* - Pliers
* - Garden Hose
* - Liquid soap or lubricant
Barrier Parts List
(Included in Hardware Pack)
4 -
#10 x 1-1/4” screws
1 - Strip of 4 Foam Pads
1 - Large Barrier Section
1 - Small Barrier Section
1 - Upper Brace
1 - Lower Base
Parts List
2 - Handrails
2 - Stringers (Legs)
4 - Upper treads
1 - Bottom tread
1 - Platform with Wedges
(See Step 4)
HANDRAIL
WEDGE
PLATFORM
ADJUSTABLE
TUBE
UPPER
TREAD
MOUNTING
BLOCK
STRINGER/
LEG
BARRIER
SECTION
BOTTOM
TREAD
Use a little liquid soap to
help with ladder assembly.
Model #6000X
Adjustable Heavy-Duty Inpool Ladder
Ladder must be attached to deck
If missing parts call - Toll free U.S./Canada - 800-635-3213 or www.conferladders.com
Safe Installation
To reduce the risk of electrocution, drowning, entrapment, falls, or other
serious injury or death:
Check building codes/permitting.
Consult your local Building Department before installation of your pool and
equipment. Pool/equipment installation must comply with the codes of the authority having jurisdiction and
may require permits (e.g., building, plumbing, electrical, zoning, etc.). Be sure that barriers (fences, gates, etc.)
restricting pool access meet local codes.
Use for intended purpose only
• Use only as a swimming pool ladder.
• This ladder is designed and manufactured for a specific pool wall height and/or deck of the pool - check
product specification and the height of your pool.
Check that you have all required parts.
Check the contents of the carton with the Parts List for this ladder.
All parts and hardware are required. If any parts are missing,
DO NOT attempt to assemble or install the ladder.
Instead, call Toll Free U.S. - 800-635-3213 or visit our web site at www.conferladders.com for assistance.
Select an appropriate location
- The ladder must be located on a level, solid base and in a location that will be
in full view of competent adult supervision when in use.
Follow all instructions
• For stable, correct assembly and installation, all instructions must be followed completely and in the
sequence shown.
• Follow the manufacturer’s recommendations for the safe use of all hand tools and equipment used during
installation.
Cordless drill only - no corded drills near pool.
Use a cordless drill for assembly and installation. To reduce the
risk of electrocution, NEVER use a corded drill in or around a pool.
Lift safely.
When lifting awkward or heavy loads, have another person help you.
Double check after installation
• Before using the product, after assembly and installation, go over the instructions and procedures again to
make sure nothing has been overlooked.
• Make sure that safety labels are installed and legible.
2
# 6000X Extension Kit
(Part # 6000X-EXT) - Raises ladder
to reach deck heights from 57” to approximately 68”. Kit
includes two extension boots, one additional ladder tread,
hardware and instructions.
ADDITIONAL ACCESSORIES MAY BE PURCHASED
SKIM-IT
(SKIMS OFF DEBRIS) - Cut cleaning time 75%
with skimmer extension that guides debris directly into your
skimmer. Fits most in-ground and above-ground pool skim-
mers. Corrosion-resistant plastic Skim-It installs in seconds
without tools.
Order online at
www.conferladders.com
