Condair DC 100-R, Инструкция по установке и эксплуатации

Страница: 13 / 52

Rev. A 09-2017
13
DC
,QGXVWULDO'HKXPLGL¿HUV
3.1.7 Microprocessors
All units are supplied standard with microprocessor controls. The microprocessor controls the following functions: regulation of the water
temperature, antifreeze protection, compressor timing, compressor automatic starting sequence, alarm reset, potential free contact for
remote general alarm, alarms and operation leds.
3.1.8 Electric enclosure
The electric switch board is made according to electromagnetic compatibility norms CEE 73/23 and 89/336. The accessibility to the board
is possible after removing the front panel of the unit and the OFF positioning of the main switch. If the unit is endowed of cabinet, after its
removal.
3.1.9 Control and protection devices
All units are supplied with the following control and protection devices: defrost thermostat, which signals to the microprocessor control that
a defrost cycle is needed and controls its termination, high pressure switch with automatic reset, compressor thermal overload protection,
fans thermal overload protection.
3.1.10 Test
All the units are fully assembled and wired at the factory, carefully evacuated and dried after leak tests under pressure and then charged
with refrigerant R410A. They are all fully operational tested before shipment. They all conforms to European Directives and are individually
marked with the CE label and provided with Conformity Declaration.
3.2 Other versions
3.2.1 Version with cabinet (A)
Unit suitable for vertical installation.
3.2.2 Ducted version (P)
Unit suitable for vertical ducted installation in technical room.