3
PART NUMBERS
529 5135-01-120
Protocol Station Remote Alarm 120 VAC version
529 5135-01-220
Protocol Station Remote Alarm 220 VAC version
USER RESPONSIBILITY
Service to this product should only be performed by CONCOA or an authorized CONCOA agent. Requests for
service may be made through CONCOA CUSTOMER SERVICE at 1-800-225-0473. Written requests may
be made using CONCOA’s FAX number at 1-757-422-3125 or CONCOA’s E-MAIL at [email protected].
CONCOA accepts no responsibility for damage or injury if this product is modified in any way.
CONCOA assumes/accepts no liability or responsibility for damage to individuals or equipment that may occur
when using this product.
INTENDED USE OF PRODUCT
The Protocol Station Remote Alarm is used to monitor and report the status of inlet pressure on Protocol Stations.
The Alarm can be configured to operate with either normally open or normally closed pressure switch contacts.
The Alarm contains a set of relay contacts that can be used to control any device that can be activated using a
normally open or normally closed switch. One example of such a device would be the CONCOA telephone
dialer (PN 5295306).
Connections to the Alarm are made through input and output connectors. Customer supplied cables are easily
soldered to the connectors prior to plugging the connectors into the Alarm. For connector pin assignments
please refer to the “CONNECTING THE ALARM” section of this manual.
GENERAL SAFETY PRACTICES
Basic safety precautions must be followed to reduce the risk of fire, electrical shock or injury.
a. Connect the Alarm to the correct line voltage. The product is supplied with either a 120 VAC or
220VAC wall mount power supply.
b. While the Alarm is dust and moisture resistant, it should be installed in a location where it will not
be subjected to rain or high concentrations of dust. Never pour or spray liquids directly onto the
product.
c. Install the Alarm where the ambient temperature range while operating is between 0°F and 140°F.
d. Do not install the product in hazardous locations.
e. If product appears damaged in any way, do not use and request service from CONCOA.
f. Do not attempt to operate the Alarm with the cover off.
DESCRIPTION OF PRODUCT
The Protocol Station Remote Alarm is capable of operating at either 120VAC or 220VAC depending on which
wall mount power supply it was ordered with. It is capable of providing operating status for a bank tanks for
one CONCOA protocol system. The Protocol Station Remote Alarm provides power to operate the pressure
switches.
A protocol product that is configured with the alarm option is equipped with one pressure switch gauge. A
pressure switch gauge is used to monitor and report the state of the pressure for the Protocol System.
Содержание 529 Series
Страница 2: ...THIS PAGE INTENTIONALLY LEFT BLANK...
