58
59
EN
EN
VP4165
VP4165
LED INDICATOR
State
LED indicator colour
On
Blue
Low battery
Blue flashing
Empty battery
Red flashing
Charging
Red
Charging completed
Blue
Bad battery (charging)
Red and blue flash alternately
Battery care
To prolong the life of the vacuum cleaner battery, follow these instructions:
Do not leave the vacuum cleaner fully charged or completely discharged for a long time.
Prolonged discharged of the battery will result in loss of its capacity.
Do not let the vacuum cleaner to be completely discharged.
It is ideal to keep the capacity of the battery between 20 % - 80 %.
USE
Operation of the rod vacuum cleaner
1. Press the on/off button to turn on the rod vacuum cleaner.
2. During operation, press the ECO speed button and select between high speed and ECO speed. At high speed, the
suction power of the appliance will be at its maximum, while the ECO speed mode will provide less noise and longer
operating times.
3. During operation, the LED indicator on the rotating brush nozzle lights up.
4. If the appliance is standing in the upright position, always turn the rod vacuum cleaner off as the bristles could
damage the floor or the carpet.
5. If you are not using the appliance, it is recommended to store it in an upright position leaning up against the wall. Do
not let children play with the appliance.
Operation of the hand-held vacuum cleaner
1. Press the button on the hand-held vacuum cleaner and release the vacuum from the rod vacuum cleaner. Press the
on/off button to turn on the hand-held vacuum cleaner. The hand-held vacuum cleaner starts to vacuum.
2. Vacuum the surface in any direction until the surface is clean.
3. Press the on/off button to turn off the hand-held vacuum cleaner. Before turn off, turn the front of the hand-held
vacuum cleaner upwards to prevent the dust from falling out of the dust cup.
4. Before vacuuming, empty and clean the dust cup.
5. Insert the hand-held vacuum cleaner back into the rod vacuum cleaner.
CLEANING AND MAINTENANCE
Emptying the dust cup
Empty the dust cup after each use or when the dust level exceeds the maximum level. Always switch off the appliance
before cleaning it.
•
Press the release button on the top of the vacuum cleaner, release the dust cup, empty it and remove the filter
holder from it.
•
Press both sides of the external filter and remove the filters from the dust cup. Dump the dirt.
•
Wash the filters. Allow them to dry before reassembly.
NOTE: Do not clean the vacuum cleaner with thinner or chemical solutions, as this will damage the appliance
•
Insert the internal and external filters back into the dust cup Make sure you dry the inside of the dust cup.
•
Place the dust cup back into the hand-held vacuum cleaner.
