Concept2 VP4080, Руководство пользователя

Страница: 30 / 69

58 59
VP4080 VP4080
EN EN
Mounting the turbo nozzle
Push the vacuum cleaner body into the turbo nozzle. You will hear a click when seated in the correct position. To
remove the turbo nozzle, press the turbo nozzle release button (7) and pull to disconnect.
USE
Operation of the rod vacuum cleaner
1. Press the ON/OFF button (1) to turn the appliance on.
2. The speed switch (2) can be used to change the vacuum cleaner power during vacuuming. At high speed, the
suction power of the appliance will be at its maximum, while the low speed mode will provide less noise and longer
operating times.
3. If the appliance is standing in the upright position, always turn the rod vacuum cleaner off as the bristles could
damage the floor or the carpet.
4. Press the ON/OFF button (1) to turn the appliance off.
Charging the appliance
1. Ensure that the vacuum cleaner is off.
2. Ensure that the charging base is placed on a level surface.
3. Place the rod vacuum cleaner into the charging base.
4. Connect the charger connector to the charging base and plug the charger into a power outlet.
Battery indicator
Note
: The battery indicator has 3 boxes to indicate the current battery status
1. When the battery is fully charged, 3 boxes light green. They gradually decrease to 2 and 1 during operation and
discharge.
2. When the battery is low, 1 box flashes green.
3. When the vacuum cleaner is charging, the indicator boxes flash red, gradually from 1 to 3 boxes. When the vacuum
cleaner is fully charged, all 3 boxes light up green for a few minutes. Then they turn off.
Note : Even if the rod vacuum cleaner is on, if it is placed in the charging base, it automatically shuts off. While the rod
vacuum cleaner is charging, the vacuum cleaner has a current protection element. Even if you press the power button,
the appliance will remain switched off.
CLEANING AND MAINTENANCE
Emptying the dust cup
Empty the dust cup after each use or when the dust level exceeds the maximum level. Always switch off the appliance
before cleaning it.
• Press the dust cup release button (6) to release the dust cup.
• Pull out the filters of the dust cup and empty the dirt.
• Assemble the dust cup in the opposite way and place it in the vacuum cleaner body.
Wash the filters. Allow them to dry before reassembly.
NOTE : Do not clean the vacuum cleaner with thinner or chemical solutions, as this will damage the appliance.
Brush maintenance
• Turn the lock at the bottom of the turbo nozzle to the “unlocked” position (indicated by the open lock)
• Remove the brush lock.
•
Remove the brush from the turbo nozzle.
• Remove hair and other dirt from the brush.
• Put the brush back in the turbo nozzle.
• Reinsert the lock and turn it to the “locked” position (indicated by the closed lock).