EN
25
OPK 4160
OPERATING INSTRUCTIONS
Before the first use
Prior to operating a new appliance for the first time, wipe it with a wet and then a dry cloth.
Ventilation mode
In this mode, the exhausted vapors are ventilated through the output pipe into the airing shaft and out of the room. If
the carbon filter is installed in the appliance,
remove it
(Refer to the Cleaning and Maintenance chapter).
1. By pressing the symbols 1 - 3 you may select the required level of output of the ventilating fan. The ventilating fan is
switched ON. A control light will be lighting above the selected output level.
2. Press the selected symbol again after use, the ventilating fan of the appliance will be switched OFF and the control
light will turn off.
Re-circulation mode
If you have no possibility to exhaust the air out of the room, the re-circulation mode can be selected. In this mode, the
exhausted vapours are filtered by metal filters and the carbon filter. The active carbon in this filter absorbs smells and
the cleaned air flows back in the room through the holes in the upper chimney cover. For this mode, it is necessary
additionally to buy and install the corresponding carbon filter (see the paragraph Cleaning and maintenance).
3. By pressing the symbols 1 - 3 you may select the required level of output of the ventilating fan. The ventilating fan is
switched ON. A control light will be lighting above the selected output level.
4. Press the selected symbol again after use, the ventilating fan of the appliance will be switched OFF and the control
light will turn off.
Switching the lighting on/off
By pressing the symbol the lighting is switched on. By a repeated pressing of the symbol , the lighting turns off.
5 min. delayed turn-off function
1. Select the required level of output of the ventilating fan (1, 2 or 3). The ventilating fan is switched ON. A control light
will be lighting above the selected output level.
2. By long pressing of the selected symbol you will activate the delayed OFF-function of the ventilation fan. Operating
light is blinking.
3. Ventilating fan of the appliance will switch off automatically in 5 minutes. Time of the delay is pre-set and it is not
possible to change it.
Note:
When you press the symbol of the selected output again during the counting down, the delayed OFF-function
will be cancelled and the ventilation fan will be working in the mode of manual control; the operation control light will
be lighting permanently.
CLEANING AND MAINTENANCE
• Prior to any maintenance or cleaning, disconnect the power cord from the mains or switch off the circuit breaker of
the appliance mains outlet.
•
Do not immerse the supply cable, the plug, or the appliance itself in water or any other liquid.
• Set all controls to the OFF position.
• Clean the external surface of the appliance by a soft wet cloth, or respectively, you may use a neutral cleaning agent.
• Do not use steel wool, coarse sponges, abrasive cleaners, solvents or aggressive cleaning agents.
• Do not use an autoclave to clean the appliance!
25
OPK 4190 OPK 4160 OPK 4160wh
EN
