Concept2 MNV7760ds, Руководство пользователя

Страница: 144 / 154

144
EN
MNV7760ds
Disassembling
If you disassemble the appliance, it is important to follow the steps in the correct order:
1. First, unplug the power cord from the mains (pull the plug or switch off the circuit breaker).
2. Close the water supply.
3. Loosen the drain and inlet hoses.
4. Loosen the fastening screws.
5. If the dishwasher is attached to the base plate, remove it.
6. Pull the dishwasher out while gently pulling the drain and inlet hoses and the power cord.
Disconnection of the water supply
1. Close the water supply (the tap).
2. Press the button to release the water pressure in the inlet hose. Water cannot accidentally spurt out when the
water pressure is low.
3. Unscrew the inlet hose from the tap.
Draining excess water from hoses
If the drain hose is connected to the waste pipe at the maximum allowable height, the excess water cannot be
drained completely. It is necessary to disconnect the drain hose and lay it as low as possible. To capture the water,
you can use a shallow container e.g. a basin.
TROUBLESHOOTING
You can remove most of the minor malfunctions by yourself, there is no need to call the service centre. The following
overview will help you find the causes of occurring errors.
Defect description Possible cause Solution
The appliance does not work
Faulty circuit breaker
Check the circuit breaker in the switchboard if it is
in working condition. Unplug all other appliances
that are connected to the same circuit.
The power cord plug is not
plugged in the wall outlet.
Make sure the appliance is switched on and the
door is closed.
Check the connection of the cord.
Low water pressure
Make sure the water supply is open and the inlet
hose is tightly connected to the water supply tap
or the hose is not bent.
Door is not closed properly. Make sure that the door is closed tightly.