Concept2 MNV7760ds, Руководство пользователя

Страница: 136 / 154

136
EN
MNV7760ds
PUTTING THE APPLIANCE INTO OPERATION
Starting the washing program
1. Open the appliance door.
2. Check the amount of the regenerating salt and refill if needed.
3. One by one pull out the upper and lower rack, load the dishes and then slide the racks back. We recommend
loading the lower rack first and then the upper rack (see „Loading dishware“).
4. Make sure that the water tap is open. Close the door of the appliance.
5. Press button (1) to turn the appliance on.
6. Select the desired washing program by pressing the button (2). The selected washing program is indicated by
the indicator light of the respective washing program (9).
7. If you require a delayed start, press the delayed start function button (4) repeatedly. You can delay the start of
the washing for up to 24 hours. Press this button once to delay the start of washing by one hour.
8. If the dishwasher is only half loaded with dishes, press button (7) to launch the half load option function.
Washing is performed in both (upper and lower) racks, the water consumption is reduced and the length of the
program is shortened.
9. After selecting the program and adjusting close the door of the appliance. The washing program or the
countdown of the delayed start will start.
10. You will hear an eight-fold beep sound after the washing program is done.
11. Press button (1) to turn the appliance off.
12. Hot dishes are very fragile. We recommend leaving the dishes to cool down for about 15 minutes before
unloading.
13. Unload the lower rack first and then the upper rack to prevent the excess water from the upper rack flowing
down on the dishes in the lower rack.
Caution! Be careful while opening the door of the appliance, a large amount of water vapour can be released or
hot water can spurt. There is a danger of scalding!
Changing the program during the running washing program
The washing cycle can only be changed if it is not running for a long time, otherwise the detergent could already be
released and the dishwasher could have drained the washing water. In that case, the dishwasher must be reset and
the detergent dispenser must be refilled (see chapter “Filling the detergent dispenser”). To reset the dishwasher,
follow these steps:
1. Press the Start/Pause button (8) to pause the washing.
2. Press the Program button (2) for more than 3 seconds to cancel the program.
3. Press the Program button (2) to select the desired program.
4. Press the Start/Pause button (8), after 10 seconds the dishwasher will start.
Note:
• If you open the appliance door during the running wash program, the program will be paused. Signal lights go off.
• A beep sound occurs every minute to warn the door is open during the running program.
3 sec