Concept2 MNV4160, Руководство пользователя

Страница: 150 / 170

150
EN
MNV4160
PUTTING THE APPLIANCE INTO OPERATION
Starting the washing program
1. Open the appliance door.
2. Check the amount of the regenerating salt and refill if needed.
3. One by one pull out the upper and lower rack, load the dishes and then slide the racks back. We recommend
loading the lower rack first and then the upper rack (see „Loading dishware“).
4. Make sure that the water tap is open. Close the door of the appliance.
5. Press button (1) to turn the appliance on.
6. Select the desired washing program by pressing the button (2). The selected washing program is indicated by
the indicator light of the respective washing program (6).
7. If you require a delayed start, press the delayed start function button (3) repeatedly. You can delay the start of
the washing for up to 24 hours. Press this button once to delay the start of washing by one hour.
8. If the dishwasher is only half loaded with dishes, press button (4) to launch the half load option function.
Washing is performed in both (upper and lower) racks, the water consumption is reduced and the length of the
program is shortened.
9. After selecting the program and adjusting close the door of the appliance. The washing program or the
countdown of the delayed start will start.
10. You will hear an eight-fold beep sound after the washing program is done.
11. Press button (1) to turn the appliance off.
12. Hot dishes are very fragile. We recommend leaving the dishes to cool down for about 15 minutes before
unloading.
13. Unload the lower rack first and then the upper rack to prevent the excess water from the upper rack flowing
down on the dishes in the lower rack.
Caution! Be careful while opening the door of the appliance, a large amount of water vapour can be released or
hot water can spurt. There is a danger of scalding!
Changing the program during the running washing program
If you decide to change the currently running program, make sure there is enough detergent in the dispenser,
or whether it was used and it is needed to be refilled before starting a new washing program (see „Loading the
detergent“).
1. Open the door slightly to pause the running washing program. Wait until the spray arms are completely
stationary.
2. Press and hold button (2) for more than 3 seconds. The appliance will switch to standby mode in which you can
change the washing program setting.
3. Close the door after you are done resetting. The washing cycle will continue after a few seconds.