Concept2 LK5455ss, Руководство пользователя, Страница: 67 / 76

67
EN
LK5455wh / LK5455ss
INSTALLATION OF THE APPLIANCE
• Defects caused by improper installation are not covered by the warranty.
•
Installation is the responsibility of the customer not the manufacturer.
• The manufacturer bears no responsibility for damage caused to people, animals or property due to incorrect
installation.
•
Place the appliance on a flat place in a well-ventilated are.
• Do not place the appliance under the direct sun shine.
• The appliance should be placed at least 10 cm from the wall at the back and both sides. There should be a free space
of approximately 30 cm above the appliance as it needs to ventilate freely.
• If necessary, use the adjustable feet at the bottom of the appliance to align the appliance in a horizontally stable
position.
CONNECTION TO THE MAINS
• Make sure the mains voltage and current protection correspond to the values on the rating plate of the appliance.
We recommend using a separate outlet with a 10 A circuit breaker.
•
Only use grounded sockets.
• Do not use multiple sockets, plugs and extension cords. There is a risk of overheating.
• The plug of the power cord on the appliance must be freely accessible even after the installation.
• Changes in a connection may only be performed by a qualified professional.
• Electrical safety of the appliance can be guaranteed only if the protective terminal of the appliance is connected to
the protective conductor of the mains.
• The manufacturer bears no responsibility for damage to persons or property as a result of missing or bad protective
connection.
• The power cord must be positioned in a way that it is not deformed or excessively bent.
DOOR SWING DIRECTION
1. Switch off the circuit breaker or remove the plug from the wall outlet. When disconnecting the unit from the wall
outlet, never pull the power cord, grasp the plug end and disconnect it by removing it from the receptacle.
2. If you have any food and drinks in the refrigerator door compartments, remove them.
3. Remove the upper plastic covers, the upper hinge of the refrigerator (Fig. 1) and disconnect the connector
located at the upper hinge of the refrigerator (Fig. 1). Remove the refrigerator door and place it in a safe place.
4. Remove the blind plugs and the middle hinge of the refrigerator (Fig. 2). Remove the freezer door and place it in
a safe place.
5. Remove the blind plugs and the bottom hinges of the freezer (Fig. 3).
6. Move the pin for fixing the freezer door to the other side of the freezer bottom hinge (Fig. 3). Install the freezer
bottom hinge on the other bottom side of the unit as shown in Fig. 3.
middle hinge
decorative cover
Fig. 1
Fig. 2
Decorative cover
upper hinge
upper hinge cover
decorative cover
Hinge blind plug
Upper hinge
Upper hinge cover
Middle hinge