Concept2 ETV7360, Руководство пользователя

Страница: 75 / 80

APPLIANCE INSTALLATION
• Do not lift the appliance by holding it by
the handle of the door!
• Defects caused by incorrect installation
are not covered by the warranty.
• Only the customer, not the manufacturer, is
responsible for the appliance installation.
• The manufacturer bears no responsibility
for damage caused to people, animals or
objects as a result of incorrect installation.
• To ensure correct function of the appliance,
install it in suitable furniture.
• The unit should be installed in standardi-
sed kitchen furniture designed for built-in
appliances or in properly adapted furniture
of dimensions according to Fig. 5.
• The appliance may be located either under
a kitchen cabinet or in a stand-alone cabi-
net (Fig. 5).
• The kitchen furniture must be made of
heat-resistant material (at least 120 °C). The
materials and used glues must be resistant
to the warming of the unit according to the ČSN EN 60335-2-6 standard. Materials and glues which do not
meet the stated standard may deform or come unstuck.
• All the protective covers must be fixed at their positions so that it is not possible to remove them without
using a special tool.
• The rear board of the kitchen unit must be removed to ensure proper circulation of air around the
appliance.
• If a cook top is above the appliance, a gap of at least 50 mm must be between them.
Connecting to the mains
• Make sure the mains voltage and current protection correspond to the values on the rating plate. We
recommend using a separate outlet circuit with a 16A circuit breaker.
• Use grounded wall outlets only.
• Do not use adapter sockets, connectors or extension cables. They could create a risk of overheating.
• The supply cable plug has to be freely accessible even after the installation of the unit.
• Only a qualified expert can perform connection changes.
• The electrical safety of the appliance can only be guaranteed if the protective terminal of the appliance is
connected to the protective conductor of the mains.
• The manufacturer bears no responsibility for damage caused to people or objects as a result of a missing
or bad protective connection.
• The power cord must be located so that it does not come into contact with hot parts of the appliance and
so that it is not deformed or excessively bent.
18
18
0
13
600
595
585
560
560
50
min.
570
min.
570
555
560
595
595
20
Fig. 5
EN
75 ETV7360