43
ETV6660
EN
• Only a qualified expert can perform connection changes.
• Electrical safety of the unit can only be guaranteed if the protective terminal of the unit is connected with the
protective conductor of the mains.
• The manufacturer bears no responsibility for damages caused to people or things as a result of missing or bad
protective connection.
• The power cord must be located so that it does not come into contact with hot parts of the unit and so that it is
not deformed and excessively bent.
When installing the unit, follow these instructions:
1. Remove all the packaging and marketing materials from the unit before the first use.
2. For the required built-in box dimensions see Fig. 5. For the sake of efficient air circulation the unit has to be
located according to the dimensions on the pictures and the design of the cabinet must enable air flow into its
bottom part. The gap behind the rear wall of the built-in oven must be at least 50 mm.
3. Put the unit on the edge of the cabinet and run the power cord through the rear wall of the cabinet so that its
plug is accessible after installation.
4. Push the unit carefully to the selected place in the cabinet. Be careful not to squeeze the power cord.
5. Attach the unit to the cabinet by screwing four screws in the holes in the front wall. The holes can be seen after
opening of the door (see Fig. 6).
6. Plug the supply cable in the wall outlet.
Dismounting
If you are dismounting the unit, it is important to proceed correctly:
1. First unplug the power cord from the mains (pull out the plug or switch off the circuit breaker).
2. Release the attachment screws.
3. Slide out the unit and at the same time pull out the power cord carefully.
Fig. 5
Fig. 6
