EN
47
ETV4560
3. Put the unit on the edge of the cabinet and run the power cord through the rear wall of the cabinet so that its
plug is accessible after installation.
4. Push the unit carefully to the selected place in the cabinet. Be careful not to squeeze the power cord.
5. Attach the unit to the cabinet by screwing 4 screws in the holes in the side walls of the unit. The holes can be
seen after opening the door.
6. Plug the supply cable into the wall outlet.
Removal
To uninstall the unit, it is important to proceed correctly:
1. First, unplug the power cord from the mains (pull out the plug or switch off the circuit breaker).
2. Remove the attachment screws.
3. Slide out the unit and at the same time pull out the power cord carefully.
Connect the power cable.
1. Open the cover on the rear panel.
2.Connect each cable as shown below.
3. Close the cover
