Concept Smoke Screen Sentinel S100, Инструкция по установке и эксплуатации

Страница: 6 / 36

5
1.3 INTRODUCTION
This manual covers the Sentinel S70 / S100 / S150 v7 v1.2, which can be upgraded to a S with the addition
of an IP module. The manual also covers the S70 / S100 / S150 v6; however, this model cannot be upgraded to
S without replacement parts and firmware upgrade. Some of the menu items listed are not available in earlier
firmware.
Before commencing installation of the Smoke Screen ensure that you have all the following parts supplied in the box:
• 1 x Smoke Screen.
• 1 x Mounting bracket.
• 1 x Smoke fluid consumable.
• 2 x 12v batteries.
• 1 x Additional 30-degree Nozzle for wall mounted installation.
•
1 x Warning sign and documentation.
You will also need:
•
Mains power supply: an unswitched 13 amp fused spur connected to a dedicated breaker.
•
Connections into the alarm panel or other triggering system.
•
PIR (or equivalent) to provide the hold-off where required.
•
Ethernet connection if a S is being used.
1.4 OVERVIEW
The Smoke Screen is designed to form part of an existing intruder alarm system but may also be configured as a
‘stand-alone’ system or as part of a centrally monitored, command and control system. A typical installation is shown
in the following schematic:
The optional Smoke Screen Interface allows easy connection to alarm systems, visual and audible status monitoring,
the ability to isolate smoke system for alarm servicing, and simple activation testing of the smoke system.