You need these tools for installation:
❒
wire strain relief
❒
16- or 18-inch adjustable wrench
❒
set of Allen wrenches
❒
½ inch open or box end wrench
❒
flashlight
Plan the location.
Make sure the area where the saw
is installed has the following:
●
A grounded power source. Check the saw’s serial-
al tag for the correct amps, voltage, phase and
cycles. All wiring should be completed by qualified
personnel and should comply with your region’s
electrical codes.
●
Clearance for safe operation and maintenance.
Make sure there is enough clearance around the saw
for maintenance and servicing.
P
REPARING FOR
I
NSTALLATION
UGE058/0803
CTS Saw
I
NSTALLATION
3-3
1
2
WARNING: Improper installation, oper-
ation, or servicing may result in
equipment damage or personal injury.
This equipment should only be installed, adjust-
ed, and serviced by qualified technical person-
nel who are familiar with the construction, oper-
ation, and potential hazards of this type of
machine.
All wiring, disconnects, and fuses should be
installed by qualified electrical technicians in
accordance with electrical codes in your region.
Always maintain a safe ground. Do not operate
the equipment at power levels other than what
is specified on the machine serial tag and data
plate.
