Comunello QUAD 24V HP, Инструкция по установке и эксплуатации

Страница: 37 / 156

37 COMUNELLO ®Copyright 2021 - All rights reserved
ENGLISH
6 MENU DESCRIPTION AND PROGRAMMABLE FUNCTIONS
The control panel has a MAIN MENU and three sub-menus called EXTENDED MENUS to customize the programming and the various system functions.
Pressing the SELECT button several times in succession you can scroll through the menu displayed by the 7 LEDs to choose the desired function (flashing LED
correspondingly flashing) and change its functionality with the SET button (the LED becomes fixed with function enabled or, conversely, off with function disabled).
THE “”LEV”” LED STATUS INDICATES WHICH MENU IS ACTIVE”
Use the SELECT key by pressing it several times to select the desired function (the corresponding LED flashes) in the displayed menu and confirm with the SET key:
The first available menu is the MAIN menu summarized in Tab no. 2:
MAIN MENU
• Press the SELECT button and select the desired function from
the main menu
The LEV function LED stays on FIXED:
LIVEL 0 - MAIN MENU
LED FUNCTION DESCRIPTION LED ON LED OFF DEFAULT
L1 STEP BY STEP Selection of the opening logic Open-Stop-Close-Stop (it closes after the pause time in a partial
opening phase) Automatic (Open-Close)
L2 CODE TX Storage of remote controls Memorised controls Empty storage
L3 CONDO Activate the "Condominium"
function After the first one, the other inputs are ignored during the opening and
the pause time Disabled function
L4 MOTOR TIME Storage of the motor stroke with
slowdowns Stored stroke 30 seconds, without slowdown
(default)
L5 PAUSE TIME Automatic closing setting Automatic closing period stored Not active
L6 DELAY Adjustment of the delay between
the 2 leaves 4 sec. in OPEN, adjustable from 4 to max. 15 sec. in CLOSE Leaf delay disabled
L7 AUTO PROGRAM Self-learning of the stroke with
slowdowns Memorized self-learning of the stroke Disabled function
Table 2
The second menu is the one defined as EXTENDED 1 and to access the programmable functions follow the instructions given in Tab. 3:
EXTENDED
MENU 1 • Press the SELECT button and scroll the LED menu until you
reach the LEV LED;
• Press SET once to access the EXTENDED menu 1.
The LED of the LEV function FLASHES with this frequency
LIVEL 1 - EXTENDED MENU 1
LED FUNCTION DESCRIPTION LED ON LED OFF DEFAULT
L1 HOLD-TO-RUN Hold-to-run input Enabled function Disabled function
L2 PEDESTRIAN /
SINGLE LEAF
PUSHBUTTON Configuration of pushbuttons
inputs PP and PPED N.O. PPED button acts like single leaf (performing the stored stroke of
MOT1)
OPEN and CLOSE by 2 different buttons:
PP: Open
PPED: Close Partial opening/pedestrain leaf
PP: Open / Close button
PPED: partial open of MOT1
L3 PEDESTRAIN
BUTTON / DS3 Configuration of the PPED input
as partial opening or as additional
photocell input Configuration of N.O. PPED input as DS3 Configuration of the PPED input
as N.O. Pedestrian input
L4 PHOTOTEST Perform the photocell test before
each movement Enabled function Disabled function
L5 DS2 STOP IN
CLOSE Configuration of DS2 photocells
input STOP in CLOSE once the contact is open, then reversal Reversal in CLOSE
L6 DS1 PARTIAL
INVERTION Configuration of DS1 photocells
input Partial reversal in CLOSE Complete reversal in CLOSE
L7 BLOCK / 8K2 Configuration of N.C. STOP or 8.2
K Ohm resistive input. 8.2 K Ohm resistive input configuration N.C. STOP pushbutton
Table 3