Comtech EF Data Vipersat CDM-570L, Руководство пользователя

Страница: 32 / 146

Initial Configuration
2-10
Vipersat CDM-570/570L User Guide
If this Hub unit is providing the TDM outbound, a route statement or state-
ments defining satellite communications with the Remote units must be
entered as well. One recommended option is to enter a single super-route
that will handle satellite communications with all of the remote subnets; an
example of this is shown as Route002 in figure 2-6, above.
4. Enter S at the command prompt in figure 2-6 to save the settings to flash.
Set the Satellite Modem Configuration
1.
Enter M from the Main Menu , then enter C from the Satellite Modem
menu to access the Configuration screen.
2. Enter T to access the Tx Configuration screen shown in figure 2-7. Set
the Tx parameters for Frequency , Data Rate , FEC , Code Rate , and
Modulation as specified by the network administrator.
Note that only Turbo Product Coding is acceptable for FEC when the
CDM-570/570L is running in Vipersat mode.
Figure 2-7 Tx Configuration screen
3. Enter R to access the Rx Configuration screen, and set the Rx parameters
as specified by the network administrator.
4. Save the settings to flash by entering S at the command prompt.