Comtech EF Data Vipersat CDM-570L, Руководство пользователя

Страница: 31 / 146

Chapter
2 -
Quick Start Configuration
2-9
Initial Configuration
that must be created is a gateway address for routing the data traffic that is
received by the unit.
1.
From the Main Menu shown in figure 2-1, select Route Table by entering
R at the command prompt.
2. From the Configuring the Route Table screen shown in figure 2-6, enter
1 at the command prompt to set the first route that will define the default
gateway.
Figure 2-6
Configuring the Route Table screen
In a Hub configuration, the default route will typically point to a router on the
same LAN as the CDM-570/570L Hub unit.
In a Remote configuration, the default route will typically point to the satellite
modem used for communications back to the Hub.
3. When prompted, enter the Route Name (GW), the IP Address , the
Number of Bits in the subnet mask, the Route Interface (Ethernet or Sat-
ellite), and the Next Hop address. The system administrator can supply
this information, if necessary.
In a Hub role, for example, enter the name of the route (e.g., DFG ), enter
0.0.0.0 for the destination IP address and 0 for the mask, enter E for
Ethernet interface, then enter the IP address of the appropriate router or
modem for the next hop.