Comtech EF Data CDD-562AL, Инструкция по установке и эксплуатации

Страница: 124 / 244

CDD-562AL/564A/L Multi-Channel Demodulator Revision 0
Telnet and CLI Operation MN-CDD562AL564AL
9–18
9.2.2.2.1 Ethernet Interface screen
Go to the Ethernet Interface screen from the Interface Configuration screen.
Mgmt MAC Address , keystroke: none, read-only
•
The MAC Address sets the hardware destination MAC Address. This address is used when an
Ethernet packet goes to the demodulator Ethernet Interface that is used for management over
Web/SNMP. This address is unique, and is assigned permanently at the factory.
Traffic Port Speed/Mode , keystroke: E
•
The Traffic Port Speed/Mode can vary among installations. The default setting of Auto allows the
Ethernet port to automatically negotiate its link speed on power-up.
•
Selections are:
o
1 -- Auto
o
2 -- 10 MB/sec Half Duplex
o 3 -- 100 MB/sec Half Duplex
o 4 -- 10 MB/sec Full Duplex
o 5 -- 100 MB/sec Full Duplex
Mgmt IP Address , keystroke: I
•
This is the IP Address assigned to the Ethernet Interface used for management over Web/SNMP.
This is the same as Traffic IP when Dedicated Management Port is enabled.
o Enter the IP address in aaa.bbb.ccc.ddd format
Mgmt Subnet Prefix Length , keystroke: M
•
Specifies the Subnet Mask assigned to the Ethernet Interface.
o
Enter the subnet mask prefix length (valid range is from 8 to 30).
DM/Red Traffic MAC Address , keystroke: none, read-only