Operating instructions for the electronic-lock
SOLUTION PREMIUM Hotel Room Safe
SOLUTION Electronic Safe
7
GB USA
ENGLISH
VERY IMPORTANT:
Please read the instructions
carefully before using the safe or setting the lock.
We are unable to accept any responsibility for issues
that are caused by incorrect use and user error.
The safe is delivered with the default factory
master code 8-8-8-8-8-8.
We recommend, for security reasons, that you
change the factory master code.
INITIAL OPERATION
Remove the cover of the battery compartment
found inside the safe door by removing the screws.
Insert four batteries of 1,5 Volt AA (please check
the battery polarity is correct).
GENERAL
To correct a false entry, press the key
CLEAR.
Verify the battery voltages by pressing the key
LOCK
if on the display appears
bA-HI
the battery
power level is OK. If on the display appears
bA-Lo
then please change the batteries.
LOCKING –
SAVING THE GUEST USER CODE
Enter your personal user code (Between three and
six numbers).
Confirm your entry by pressing the key LOCK.
The display will now show CLOSE.
The safe will now lock and the display shows
CLOSEd and your code.
The safe door is now locked and secure.
OPENING
WITH THE GUEST USER CODE
Enter a guest code selected (Between three and
six numbers).
The display shows „–OPEN-”
The Safe will now open and the display shows
„OPENEd”.
The safe door is now unlocked.
OPENING
WITH THE MASTER CODE
Press twice the key CLEAR Enter the saved master
code (upon delivery „ 8-8-8-8-8-8“)
The display shows –OPEN-
The Safe will now open and the display shows
OPENEd.
The safe door is now unlocked.
CHANGING
THE FACTORY SET MASTER CODE
With the door open and bolt work retracted, press
twice the key CLEAR.
The display shows briefly PROG.
Enter the current Master code (upon delivery it is
the factory set code 8-8-8-8-8-8).
The display shows NEW.
Enter your new master code (Must be 6 numbers).
The display shows AGAIN.
Enter again the master code selected. The display
shows dONE.
LOCK OUT PERIOD IF INCORRECT
CODES ARE ENTERED
In case of an incorrect code is entered, the display
will show
ERROR.
You have now only three further attempts left to
enter the correct code.
After fourth incorrect code, the display shows
hold-15.
This means the safe is in lock out mode for
security reasons and you be unable to gain
entry for 15 minutes please wait do not any
code for at least 5 minutes.
07+8+9 GB Solution.15.9.14 _Layout 1 15.09.14 17:00 Seite 7
