The elevator servo mount is very similar to the
aileron system. Please use the same technique
as described in the aileron section.
It is important that the long rear servo arm is
always doubled, to make the system rigid and
stiff.
Mount the servos rock hard to the phenolic
tray, and mount the pheniolic tray with the
rubber soft mounts in the stab.
Make sure again, that the servo arms are 100%
parallel, this only can be done by centering the
servos with the receiver FIRST, and then glue
the phenolic servo horns on the servo disc.
Use 2 small sheet metal screws to secure the
phenolic arm to the servo disc.
Elevator servo setup