Compool Cp3810, Инструкция по установке и эксплуатации

Страница: 9 / 43

7
Compool Cp3810
Plumb system in accordance with recommended hydraulic schematic.
1. If a Spa-side Remote is to be used, install a 3” to 6” length of 1.5” Sch. 40 pvc pipe in the
spa wall so that the Spa-side Remote will not be submerged. Positioning the top of the
pipe 1/2” below the coping. The pipe should extend beyond the finished surface and will
be cut back after tile work is completed. Connect a 1/2” conduit and run back to Power
Center. Use sweep elbows for turns.
2. Plumb solar feed and return lines between the filter and heater. Install 3-port solar valve at
the feed line. Use Compool solar valve (model SOL-2T), to allow automatic draining of
panels.
3. Systems with separate main drain and skimmer lines can use a 3-port valve to balance the
flow.
4. Glazed solar panels require a drain valve (model HW-5B) to allow draining of panels.
This prevents damage from overheating water. Install drain valve at solar feed line and
connect to the pool fill line.
5. Plumb solar feed and return lines between the filter and heater. Install 3-port solar valve at
the feed line. Use Compool solar valve (model SOL-2T), to allow automatic draining of
panels.
6. A solar booster pump should be used when distance to panels exceeds 200’, or panels are
elevated higher than 25’.
7. Plumb cleaner pump after the return valve to the pool return line.
8. A Valve Actuator can be used to direct pool return water to a waterfall. This eliminates the
need for an additional pump.
Equipment Location
With the exception of the Spa-side Remote, all equipment must be located at least 10’ from the
water’s edge. Locate equipment in the following locations.
LX-3810 Power Center - at the equipment site.
CP-3810 Control Panel - inside the house or other weather-protected area.
SNS-KIT2 Water Temperature Sensor - at the filter pump. Freeze Temperature
Sensor - at equipment pad.